Showing posts with label FSAE. Show all posts
Showing posts with label FSAE. Show all posts

Saturday, October 3, 2015

Motor Controller Photo Dump

I realized that I never made an update to the motor controller post after someone messaged me about it. Here's a photo dump for now.

 Case from Rapid Sheet Metal

Monday, March 2, 2015

Motor Controller Packaging

Quick note: This post is a work in progress. Some sections are incomplete or missing.


1. Objectives

The motor controller used in the MY2015 will be based off of the Unitek Bamocar D3 modules used in the 2014 car. The D3 controller meets the electrical requirements for our tractive system (voltage, power, control scheme) but there is an opportunity to make significant improvements for use in our application by reducing size, weight, and installation complexity. To make the most of a redesigned housing, both control modules and will be integrated into a single package.

Thursday, January 30, 2014

Constructing battery packs from prismatic cells

When the FSAE team decided to build an electric race car a few years ago, it seemed pretty likely that we could source our batteries from A123 Systems, an alumni company. They make very high quality lithium iron phosphate cells and battery packs. The packs we had hoped to get look like this:


It's a familiar story around here, but A123 went bankrupt and changed hands and we were never able to get any packs. However, we were able to get enough raw AMP20 cells for the pack we needed. A team member spent their thesis designing our custom pack based loosely on the A123 pack. I have somehow ended up on the battery sub-team and helped assemble one of our new modules. Bring on the photos.

Sunday, October 6, 2013

Motorsports CAN bus

This year I've decided to rejoin the MIT motorsports team. The team designs, builds, and races a car for one of the various FSAE competitions held each year. I was on the team for a little over a semester my freshman year working on a temperature sensor network; it went okay. Now I'm back and the team has switched to the electric competition. My main task is to compact the motor controllers such that they actually fit inside the car. Because that's moving a bit slowly, and in the interest of rekindling the blogging habit, I have a smaller project to present first.

Modern cars have electronics and sensors stuck inside just about every functional part. These bits and bobs need to talk to the main computer and eachother to be useful. Just about every car made after 1996 (and quite a few before then) use the CAN bus protocol for communication. Our car is being made after 1996 so it's going to use CAN bus. To reduce the number of wires running all over the car there will be a breakout CAN node in the front of the car. Last Saturday I mounted and wired the connectors in a laser cut panel I made the week before. It needed to be a custom job because there were all sorts of problems from the board through holes not being big enough to a lack of keyways in the panel.

TL;DR: here are some pictures of a thing I did on Saturday. Just to be clear, I didn't make the circuit or boards for this.

"Branded" boards.